Fracture Energy and Fracture Morphology after Three-Point Bending Test of Welded Joints Made of Cast Steel Designed for Use in Power Sector, with and without the Addition of Rare Earth Metals
Clicks: 302
ID: 111376
2018
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
302 views
34 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #18 of 66 articles by views in metals
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The paper reports the three-point bending test results of welded joints. The joints were made of chromium-molybdenum cast steel designed for the use at elevated temperatures. TIG (tungsten inert gas) welding technique was used. The fracture energy for particular joint zones and the stretch zone width (SZW) under the notch bottom were determined in a qualitative fracture toughness assessment. Fracture surface morphology was analyzed. The stretch zone measurement indicated a qualitative relationship between its width and the values of fracture energy. The results confirmed the influence of the modification on the character of fracture and the portions of brittle and ductile fracture in particular areas of welded joints.
| Reference Key |
kasińska2018metalsfracture
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Justyna Kasińska;Andrzej Skrzypczyk;Kasińska, Justyna;Skrzypczyk, Andrzej; |
| Journal | metals |
| Year | 2018 |
| DOI |
10.3390/met8020115
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.