Machining of circular micro holes by electrochemical micro-machining process

Clicks: 336
ID: 111203
2013
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Star

Ranked #14 of 27 articles by views in advances in manufacturing

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Machining of micro holes with micro electrochemical machining (micro ECM) process has been carried out with an indigenously developed set up. This paper describes relevant problems and solutions for the circular micro holes machining process on 304 stainless steel sheets with 60 μm thickness using high speed steel cylindrical tool of diameter 500 μm and using dilute H2SO4 as electrolyte. The taper angle variation of the machined hole is analyzed and reported for different experimental setting parameters. The minimum value of the taper angle of machined holes is achieved at the parameter setting of 0.4 mol/L H2SO4, 700 kHz, 600 ns and 21 V, for stainless steel sheets and HSS tool.
Reference Key
das2013advancesmachining Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Alok Kumar Das;Partha Saha;Alok Kumar Das;Partha Saha;
Journal advances in manufacturing
Year 2013
DOI
doi:10.1007/s40436-013-0042-1
URL
https://link.springer.com/article/10.1007/s40436-013-0042-1
Keywords
manufacturing control Machines Tools Processes Robotics Mechatronics nanotechnology and microengineering

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.