Use of Soy Flour-Tannin Adhesive for Particleboard (Dry Condition)

Clicks: 353
ID: 108469
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
In this research soy flour- tannin adhesives were used in particleboard preparation, successfully. Tow type of different tannins Mimosa (as condensed tannin) and Chestnut (as hydrolysable tannins) were used for soy resin modification. For this purpose, mimosa and chestnut tannin were added to soy adhesive with 5, 10 and 15 percent based on dry weight of soy flour. 9 percent Glyoxal was used based on dry weight of tannin for accelerate tannin reaction’s with soyflour components. Prepared soy-tannin adhesives were used in particle board manufacturing with 350×300×14 mm3 dimansion and 0.7 g/cm3 nominal density. Results of viscosity measurment showed that addition of each of tannins decreased visocosity of soy adhesive. In this study, result of thermo-mechanical analyze indicated that chestnut cloud improve adhesion behavior of soy adhesive better than mimosa. Also, Using of tannins in soy adhesive composition increase internal bonding and bending properties in manufactured particleboards.
Reference Key
ghahri2017useiranian Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Ghahri, Saman;mohebby, behbood;Pizzi, Antonio;Mirshokraie, Ahmad;Mansouri, Hamidreza;
Journal iranian journal of wood and paper industries
Year 2017
DOI
DOI not found
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.