Welding of DOCOL 1200M using micro-jet cooling
Clicks: 146
ID: 107370
2020
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
146 views
24 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #3 of 3 articles by views in przegląd spawalnictwa
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
In welding elements of the supporting structure of the means of transport, attention is paid to the high strength and good plastic properties of the welded joint. In the construction of transport means, DOCOL 1200M steel from the AHSS group is increasingly used due to their high tensile strength of steel at the level of 1200 MPa. The welds have much lower strength than the native material. In this paper, it was decided to check the weldability of DOCOL 1200M steel with the use of micro-jet cooling
Abstract Quality Issue:
This abstract appears to be incomplete or contains metadata (86 words).
Try re-searching for a better abstract.
| Reference Key |
silva2020weldingprzeglad
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Silva, Abilio;Szczucka-Lasota, Bożena;Węgrzyn, Tomasz;Jurek, Adam; |
| Journal | przegląd spawalnictwa |
| Year | 2020 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.