Experimental and numerical characterisation of rheological properties of a drop test response of a ballistic plastilina.

Clicks: 242
ID: 106010
2020
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #85 of 132 articles by views in forensic science international

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 132 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Plastilina is often used as a ballistic witness material (BWM) behind the armour to evaluate the backface signature (BFS). Indeed, it is cheap, reusable and it keeps its deformation after being impacted. Moreover, while it aims at evaluating the performance of ballistic protections when no perforation occurs, it can be subjected to a very wide range of strain/shear rates during a ballistic impact. Therefore, there is a need to improve the knowledge about the mechanical/rheological response of such a material. This paper proposes both experimental and modelling approaches to determine the response of the specific ballistic plastilina red Weible® over a wide range of shear/strain rate. A capillary rheometry analysis with control of temperature was performed up to 8.10 s. The corrections of Rabinowitsch and Bagley were applied and an attempt of the analysis of Mooney was considered. From the rheology of plasticine, a two-parameters based power-law constitutive equation was deduced. An experimental drop test was carried out using a specific standard setup. A high-speed camera was used for measuring the penetration depth of a steel ball into the plastilina. A numerical simulation of the drop test was performed by taking into account the mechanical properties of the plastilina. A good correlation was observed between the experimental and numerical results in terms of indentation depth evolution.
Reference Key
gilson2020experimentalforensic Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Gilson, L;Rabet, L;Imad, A;Coghe, F;
Journal forensic science international
Year 2020
DOI
S0379-0738(20)30100-6
URL
Keywords
numerical simulation ballistic plastilina capillary rheometry drop test indentation depth

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.