Environmental science and pollution research international

Materials (Basel, Switzerland)

Acta biomaterialia

Carbohydrate polymers

Sensors (Basel, Switzerland)

colloids and surfaces b, biointerfaces

the journal of the acoustical society of america

bioactive materials

[1] The Durability of an Organic-Inorganic Sol-Gel Interlayer in Al-GFRP-CFRP Laminates in a Saline Environment.

[2] Wear particles induce a new macrophage phenotype with the potential to accelerate material corrosion within total hip replacement interfaces.

[3] Local misorientation accelerates corrosion in biodegradable Mg.

[4] Passive guided wave tomography for structural health monitoring.

[5] In vitro degradation and biocompatibility evaluation of typical biodegradable metals (Mg/Zn/Fe) for the application of tracheobronchial stenosis.

[6] Exploration of natural polymers for use as green corrosion inhibitors for AZ31 magnesium alloy in saline environment.

[7] Corrosion of Carbon Steel in Artificial Geothermal Brine: Influence of Carbon Dioxide at 70 °C and 150 °C.

[8] Corrosion Monitoring of Reinforced Steel Embedded in Cement Mortar under Wet-And-Dry Cycles by Electrochemical Impedance Spectroscopy.

[9] Comparison of different surface disinfection treatments of drinking water facilities from a corrosion and environmental perspective.

[10] Towards revealing key factors in mechanical instability of bioabsorbable Zn-based alloys for intended vascular stenting.

[11] Effect of Incorporated ZnO Nanoparticles on the Corrosion Performance of SiO2 Nanoparticle-Based Mechanically Robust Epoxy Coatings

[12] Corrosion resistant coatings for silicon carbide heat exchanger tubes -- Volume 3. Final report

[13] Pitting Corrosion of Hot-Dip Galvanized Coatings

[14] Effect of Incorporated ZnO Nanoparticles on the Corrosion Performance of SiO2 Nanoparticle-Based Mechanically Robust Epoxy Coatings

[15] The Kinetics and Mechanism of the Selective Oxidation of 20Fe–40Ni–10Mn–30Cr Alloy

[16] Approaches to investigate the role of chelation in the corrosivity of biomass-derived oils

[17] Screening of candidate corrosion resistant materials for coal combustion environments -- Volume 4. Final report, January 31, 1997

[18] Anwendung von Impedanzmessungen zur Charakterisierung oxidischer Schichten auf Aluminiumlegierungen nach unterschiedlicher Oberflächenvorbehandlung und Korrosionsbeanspruchung in Hochtemperaturwasser

[19] Corrosion Susceptibility of Cr–Mo Steels and Ferritic Stainless Steels in Biomass-Derived Pyrolysis Oil Constituents

[20] evaluation of novel integrated dielectric barrier discharge plasma as ozone generator

[21] an investigation on corrosion protection layers in pipelines transporting hydrocarbons

[22] titanium as a reconstruction and implant material in dentistry: advantages and pitfalls

[23] la enseñanza de los conceptos de oxidación y de reducción contextualizados en el estudio de la corrosión

[24] chloride accelerated test: influence of silica fume, water/binder ratio and concrete cover thickness

[25] preparation and characterization of aminated hydroxyethyl cellulose-induced biomimetic hydroxyapatite coatings on the az31 magnesium alloy

[26] second postgraduate conservation research seminar: science museum, london, 8-9 february 1996

[27] electrochemical corrosion study via linear polarization in peas can

[28] growth, corrosion, and wear study of nanocomposite peo coating in electrolyte containing nickel sulfate

[29] wear and corrosion performances of new friction materials for automotive industry

[30] an overview of orthodontic material degradation in oral cavity

[31] mathematical evaluation of deleterious processes of fly ash-based concrete in pipelines

[32] efectos de la corrosión en el sellado marginal de la interfase diente-amalgama: un estudio in vitro effects of corrosion in the marginal sealing of the tooth-amalgam inferface: an in vitro study

[33] redesigning octopus traps

[34] structural effects of metallic chromium on its electrochemical behavior

[35] investigation on microstructural, mechanical and electrochemical properties of aluminum composites reinforced with graphene nanoplatelets

[36] dermal toxicity of colloidal nanosilver in albino rabbit: a new approach to physicochemical properties

[37] preparation and characterization of ni-tio2 nanocomposite coatings produced by electrodeposition technique

[38] an influence study of hydrogen evolution characteristics on the negative strap corrosion of lead acid battery

[39] effect of heat treatment on the wear and corrosion behaviors of a gray cast iron coated with a colmonoy 88 alloy deposited by high velocity oxygen fuel (hvof) thermal spray

[40] corrosion evaluation of orthodontic wires in artificial saliva solutions by using response surface methodology

[41] titanium implant osseointegration problems with alternate solutions using epoxy/carbon-fiber-reinforced composite

[42] corrosion behavior of superhydrophobic surfaces: a review

[43] corrosion properties in sodium chloride solutions of al–tic composites in situ synthesized by hfihf

[44] corrosion of copper pipes joints in simulated operating conditions

[45] corrosion of nickel-titanium orthodontic archwires in saliva and oral probiotic supplements

[46] investigations of the inhibition of copper corrosion in nitric acid solutions

[47] corrosion behavior of austenitic and duplex stainless steels in lithium bromide

[48] reaction products and corrosion of molybdenum electrode in glass melt containing antimony oxides and sodium sulfate

[49] kinetics and thermodynamics of the dissolution of steel in 1 mol l−1 hydrochloric acid solution in the presence of silene marmarica as environmentally friendly corrosion inhibitor

[50] analysis of translucency parameter of glass-ceramics fabricated by different techniques

[51] structural inheritance and redox performance of nanoporous electrodes from nanocrystalline fe85.2b10-14p0-4cu0.8 alloys

[52] in vitro corrosion of mg–1.21li–1.12ca–1y alloy

[53] sur l'utilisation des aciers inoxydables dans les installations vinicoles

[54] formation and protection against incrustation on the geothermal pipe by utilizing of geothermal water in the area of Ïurkov (eastern slovakia)

[55] analysis of total chloride content in concrete

[56] corrosion of magnesium and magnesium–calcium alloy in biologically-simulated environment

[57] pollutant materials and pollution control at cupertino de miranda foundation

[58] aqueous stability of alkali superionic conductors from first principles calculations

[59] synthesis and study of corrosion performance of epoxy coating containing multi-walled carbon nanotube/ poly ortho aminophenol nanocomposite

[60] analysis of naturally etched surface of brass sheathing from a nineteenth-century shipwreck

[61] thermally sprayed aluminum coatings for the protection of subsea risers and pipelines carrying hot fluids

[62] influence of edge radius of sintered-carbide tip on roughness of machined surface

[63] preparation of bimodal grain size 7075 aviation aluminum alloys and their corrosion properties

[64] an experimental study on the deterioration of paint coatings in the bilges of a sea vessel

[65] Effect of Gas Ratio on Tribological and Corrosion Properties of Ion Beam Sputter Deposited TiN Coatings

[66] Corrosion Behaviour and J774A.1 Macrophage Response to Hyaluronic Acid Functionalization of Electrochemically Reduced Graphene Oxide on Biomedical Grade CoCr

[67] Effect of Hot Rolling Reduction on the Corrosion Resistance of Mg-Li Alloys

[68] Ceramic Dusting Corrosion of Yttria-Stabilized Zirconia in Ultra High Temperature Reverse-Flow Pyrolysis Reactors

[69] Sodium corrosion behavior of austenitic alloys and selective dissolution of chromium and nickel

[70] Anticorrosion Behavior of Zeolite Coatings Obtained by In Situ Crystallization: A Critical Review.

[71] An escalation of anticorrosion and microelectrical properties of polyurethane nanocomposites from green Brassica nigra oil

[72] Synthesis and construction of a highly potent hybrid organic/inorganic anti-corrosive pigment for effective corrosion control of mild steel in simulated seawater

[73] Evaluation of extracellular polymeric substances extracted from waste activated sludge as a renewable corrosion inhibitor.

[74] A Solution-Processable, Nanostructured, and Conductive Graphene/Polyaniline Hybrid Coating for Metal-Corrosion Protection and Monitoring

[75] EFFECT OF SOLIDIFICATION RATE ON CORROSION RESISTANCE OF CAST Al-10Mg2Si IN-SITU COMPOSITES

[76] Corrosion Inhibition of Mild Steel by Poly(butylene succinate)-L-histidine Extended with 1,6-diisocynatohexane Polymer Composite in 1 M HCl

[77] Inhibition of API 5L X52 Pipeline Steel Corrosion in Acidic Medium by Gemini Surfactants: Electrochemical Evaluation and Computational Study

[78] Corrosive Environment Assessment and Corrosion-Induced Rockbolt Failure Analysis in a Costal Underground Mine

[79] Effects of Chlorides on Corrosion of Simulated Reinforced Blended Cement Mortars

[80] Epoxy Resin’s Influence in Metakaolin-Based Geopolymer’s Antiseawater Corrosion Performance

[81] The Electrochemical Variation of a Kind of Protein Staining and Food Dye as a New Corrosion Inhibitor on Mild Steel in Acidic Medium

[82] Synthesis, Cyclic Voltammetric, Electrochemical, and Gravimetric Corrosion Inhibition Investigations of Schiff Base Derived from 5,5-Dimethyl-1,3-cyclohexanedione and 2-Aminophenol on Mild Steel in 1 M HCl and 0.5 M H2SO4

[83] Anti-corrosion Properties of Areca Palm Leaf Extract on Aluminium in 0.5 M HCl Environment

[84] Hydrazide Derivatives: An Overview of Their Inhibition Activity against Acid Corrosion of Mild Steel

[85] Optimization and Electrochemical Study on the Control of Mild Steel Corrosion in Hydrochloric Acid Solution with Bitter Kola Leaf Extract as Inhibitor

[86] EFFECT OF SOLIDIFICATION RATE ON CORROSION RESISTANCE OF CAST Al-10Mg2Si IN-SITU COMPOSITES

[87] Fretting corrosion behaviour of Ti-6Al-4V reinforced with zirconia in foetal bovine serum.

[88] Carbonation treatment of recycled concrete aggregate: Effect on transport properties and steel corrosion of recycled aggregate concrete

[89] DFT Study of Azole Corrosion Inhibitors on Cu2O Model of Oxidized Copper Surfaces: I. Molecule–Surface and Cl–Surface Bonding

[90] Effect of Ce on mechanical properties and corrosion resistance of CL50D high speed rail wheel steel

[91] Deformation Analysis of Crude Oil Pipeline Caused by Pipe Corrosion and Leakage

[92] Effect of cold work and slow strain rate on 321SS stress corrosion cracking in abnormal conditions of simulated PWR primary environment

[93] Microstructure and intergranular corrosion of the austenitic stainless steel 1.4970

[94] Graphene-based polymer nanocomposites as barrier coatings for corrosion protection

[95] Production of an environmentally stable anti-corrosion film based on Esfand seed extract molecules-metal cations: Integrated experimental and computer modeling approaches

[96] Self-Repairing Composites for Corrosion Protection: A Review on Recent Strategies and Evaluation Methods.

[97] Microwave-Induced Synthesis of Chitosan Schiff Bases and Their Application as Novel and Green Corrosion Inhibitors: Experimental and Theoretical Approach.

[98] Donor-π-Acceptor-Type Configured, Dimethylamino-Based Organic Push-Pull Chromophores for Effective Reduction of Mild Steel Corrosion Loss in 1 M HCl.

[99] Reinforcement corrosion research based on electrochemical impedance spectroscopy for coral aggregate seawater concrete in a seawater immersion environment

[100] Role of protein adsorption in the bio corrosion of metallic implants - A review.

[101] Correction to: Effects of Heat Input on Weld-Bead Geometry, Surface Chemical Composition, Corrosion Behavior and Thermal Properties of Fiber Laser-Welded Nitinol Shape Memory Alloy (Journal of Materials Engineering and Performance, (2019), 28, 5, (2754-2763), 10.1007/s11665-019-04077-0)