A Rapid Process for Fabricating Gas Sensors

Clicks: 218
ID: 79132
2014
Article Quality & Performance Metrics
Overall Quality Improving Quality
0.0 /100
Combines engagement data with AI-assessed academic quality
AI Quality Assessment
Not analyzed
Abstract
Zinc oxide (ZnO) is a low-toxicity and environmentally-friendly material applied on devices, sensors or actuators for “green” usage. A porous ZnO film deposited by a rapid process of aerosol deposition (AD) was employed as the gas-sensitive material in a CO gas sensor to reduce both manufacturing cost and time, and to further extend the AD application for a large-scale production. The relative resistance change (△R/R) of the ZnO gas sensor was used for gas measurement. The fabricated ZnO gas sensors were measured with operating temperatures ranging from 110 °C to 180 °C, and CO concentrations ranging from 100 ppm to 1000 ppm. The sensitivity and the response time presented good performance at increasing operating temperatures and CO concentrations. AD was successfully for applied for making ZnO gas sensors with great potential for achieving high deposition rates at low deposition temperatures, large-scale production and low cost.
Reference Key
hsiao2014asensors Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Hsiao, Chun-Ching;Luo, Li-Siang;
Journal sensors
Year 2014
DOI DOI not found
URL
http://www.mdpi.com/1424-8220/14/7/12219
Keywords
microscopy Medicine (General) Materials of engineering and construction. Mechanics of materials Chemical technology Engineering (General). Civil engineering (General) Technology Electrical engineering. Electronics. Nuclear engineering Descriptive and experimental mechanics Science physics manufactures

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.