numerical simulation of the heat treatment of the weld for steam generator
Clicks: 148
ID: 254261
2016
Article Quality & Performance Metrics
Overall Quality
Improving Quality
0.0
/100
Combines engagement data with AI-assessed academic quality
Reader Engagement
Emerging Content
0.3
/100
1 views
1 readers
Trending
AI Quality Assessment
Not analyzed
Abstract
Heat treatment of the weld of the steam generator is investigated in this paper. Annealing is realized by system of heating elements that are placed on casing of the generator. An experiment using real parameters and a computational fluid dynamics analysis using COMSOL Multiphysics software were performed. Experimental data were compared with results of the analysis. Boundary conditions for numerical prediction had been derived on basis of results obtained from a supplementary calibration experiment. There was good correlation between predicted and measured data. Based on results it can be stated that 67 heating elements with heating output of 60-70 % of maximum range is sufficient number for required heat treatment.| Reference Key |
machkov2016metalurgijanumerical
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;A. Macháčková;P. Kuchta;Z. Klečková;R. Kocich;J. Szwed |
| Journal | journal of the formosan medical association |
| Year | 2016 |
| DOI | DOI not found |
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.