wear-dependent specific coefficients in a mechanistic model for turning of nickel-based superalloy with ceramic tools
Clicks: 292
ID: 167407
2017
Difficult to cut materials such as nickel and titanium alloys are used in the aeronautical industry, the former alloys due to its heat-resistant behavior and the latter for the low weight - high strength ratio. Ceramic tools made out alumina with reinforce SiC whiskers are a choice in turning for roughing and semifinishing workpiece stages. Wear rate is high in the machining of these alloys, and consequently cutting forces tends to increase along one operation.
| Reference Key |
norberto2017openwear-dependent
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;López de Lacalle Luis Norberto;Urbicain Pelayo Gorka;Fernández-Valdivielso Asier;Alvarez Alvaro;González Haizea |
| Journal | orbit journal |
| Year | 2017 |
| DOI | 10.1515/eng-2017-0024 |
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.